Fisher & Paykel

Fisher & Paykel DD60SAW9

Answers and step-by-step fixes from the official Fisher & Paykel manual.

What does the display say or which light is flashing?

• F code (flashing, continuous beeping): A fault has occurred. An F code means the dishwasher has detected a fault. It can often be cleared with a simple reset.
• A1: Water supply fault. The dishwasher is not getting water.
• A3: Drawer cannot drain. The drain hose or connection may be blocked or kinked, stopping water from leaving the drawer.
• A6: Spray arm problem or low water pressure. The spray arm has come loose or come off its mounting, or water pressure is too low.
• A7: Too much foam detected. The dishwasher has started an auto recovery program because it found excess foam in the drawer.
• Salt indicator glowing red: Salt reservoir needs filling. A red salt indicator means the water softener salt reservoir is running low.
• Rinse aid indicator glowing or flashing bright red: Rinse aid is low. A bright red rinse aid indicator means it is time to refill the dispenser.

Common problems

Dishes aren't coming out clean

1. Did you pick the right wash program for this load? A lightly soiled load needs a different program to heavily soiled pots and pans.
2. Can the spray arm turn freely? Check nothing is blocking it and that it's mounted correctly.
3. Are the filter plate and drain filter clean and fitted properly? A blocked or badly fitted filter stops dishes getting clean.
4. Is anything blocking the spray arm from underneath? Items sticking out under the racks or basket can stop the spray arm turning.

The dishwasher won't start

1. Is the power supply connected? Check the plug is in and the power is on.
2. Is the drawer closed firmly? The drawer needs to be fully closed to start a wash.
3. Is KEYLOCK or CHILDLOCK turned on? Either lock disables the control panel and will stop a wash starting.

The drawer won't open

1. Is CHILDLOCK turned on? CHILDLOCK locks the drawer closed. Turn it off to open the drawer.
2. Did the closed drawer auto lock just engage? If the drawer locks itself 30 seconds after closing, press any button and open it within the next 30 seconds.

Water is leaking from the dishwasher

1. Is the drain hose disconnected from the waste pipe? A loose drain hose will let water leak out.
2. Is the water inlet hose connected correctly? Make sure the inlet hose connection is secure.
3. Is the rinse aid dispenser plug closed properly? A loose plug can cause leaking or foaming.
4. Is the leak coming from somewhere else? If it's not the hoses or rinse aid plug, turn off the water and power and get help.

Step-by-step guides

Clean the drain filter, filter plate and spray arm

1. Disconnect the dishwasher from power and let it cool.
2. Twist the drain filter counter-clockwise and lift it out.
3. Separate the mesh from the holder by pinching one side.
4. Clean the filter parts under hot soapy water and rinse.
5. Click the mesh back onto the holder.
6. Push the drain filter back in and twist clockwise to lock.
7. Lift out the filter plate and clean it under hot soapy water.
8. Lift the spray arm off the impeller.
9. Shake it to dislodge particles, then rinse and wipe it.
10. Refit the spray arm and check it turns freely.

Reset the dishwasher after an F fault

1. Press power once to stop the beeping, then press it again to turn the dishwasher off.
2. Wait a few seconds.
3. Press power again to turn the dishwasher back on.

Refill the rinse aid

1. Turn the rinse aid plug anticlockwise and remove it.
2. Pour rinse aid into the opening without spilling into the drawer.
3. Wipe up any spills straight away.
4. Refit the plug and turn it clockwise until secure, with the grip upright.